Expert Answers about Cup Holder

• Tow-Rax Cup Holder # TWSP2CH Dimensions
• I went out to the warehouse and pulled the Tow-Rax 2-Cup Drink Holder, part # TWSP2CH, and took some measurements for you, which you can also see on the included image. The thickness of the material is 2.62 mm. The cup holder is 8" long x 4" deep x 2-11/16" tall. The dimensions of the upper back plate is 5-7/8". The cup hole diameter is 3" and the part weighs 2 lbs. I have included a video review of this cup holder for you to check out as well.
  view full answer...


• What Is The Cup Holder Width of the Optronics Foldable Cup Holder
• The cupholder portion of the Optronics # 2409171B is adjustable between roughty 2-1/2" and 3-3/4" so this would be a good fit for you if you're referring to the beverage holder dimensions. The casing dimensions on this cup holder are roughly 3-3/4" x 3-7/8". I've linked the review video of this part where it details the different dimensions on the cupholder and case for you to see exactly how we measured.
  view full answer...


• How Deep Are The Cupholders On This Boat Table 315-DSI-KF
• I've gone ahead and pulled the Octogon Boat Table # 315-DSI-KF from our inventory to measure for your specific question. There is a depth of 2-1/4 inches from the top of the cup holder to the very bottom. If you notice in the pictures, there is a ring at the bottom. From the top of the cup holder to the start of the ring, there is a depth of 1-3/4 inches. At the bottom the ring reduces the 3-1/2 inch diameter of the top section of the cup holder to 2-3/4 inches in diameter. The table diameter,...
  view full answer...


• What is the Diameter of the Top of the Optronics Drop In Cup Holder?
• The top diameter, including the lip, of the Optronics Drop In Cup Holder # 302B is 3-1/4" across, which is going to be slightly larger than the 3-1/6" opening on your 2020 Subaru Legacy, so this cup holder will work for you.
  view full answer...


• What Size Ball Can Fit the Thule Replacement Bike Adapter ezHitch Cup
• The diameter of the holder for the coupling ball on the Replacement Bike Adapter ezHitch Cup # 50103033 is 1.14" which is just over 1-1/8". The diameter of that mounting hole it 7/16" and then the overall thickness is 1/4" but that little indention looks to be about 3/16". Attached is a photo to further demonstrate this.
  view full answer...


• How to Use Swagman E-Spec with Aggressive Step Through Frames
• The Swagman E-Spec # S94FR will work with any step thru e-bike that weighs 70-lbs or less, so the step-through is not an issue; however, on some bikes a bike frame adapter bar like the # 64005 will be required. In most cases with the e-spec you're going to need at least 1 adapter bar since the hook closest to the vehicle does not go down very far, but the front hook will go down low enough to handle some of the most aggressive step through frames. The distance from the wheel holders to...
  view full answer...